Rigol DG822 - Page 157

Chapter 2 Command System RIGOL
DG800 Programming Guide 2-143
:SYSTem:BEEPer[:IMMediate]
Syntax
:SYSTem:BEEPer[:IMMediate]
Description
The beeper sounds immediately.
Remarks
The current on/off status of the beeper is ignored by this command. The beeper will sound immediately
when you send this command, even if the beeper is currently disabled.
:SYSTem:BEEPer:STATe
Syntax
:SYSTem:BEEPer:STATe {ON|1|OFF|0}
:SYSTem:BEEPer:STATe?
Description
Turns on or off the beeper.
Queries the on/off status of the beeper.
Parameter
Name
Type
Range
Default
{ON|1|OFF|0}
Bool
ON|1|OFF|0
ON
Remarks
When the beeper is enabled, a beep is generated when an error occurs during front panel operation or
remote operation.
Return Format
The query returns ON or OFF.
Example
:SYST:BEEP:STAT 1 /*Turns on the beeper.*/
:SYST:BEEP:STAT? /*Queries the on/off status of the beeper and the query returns ON.*/
:SYSTem:CHANnel:CURrent
Syntax
:SYSTem:CHANnel:CURrent {CH1|CH2}
:SYSTem:CHANnel:CURrent?
Description
Selects the current channel.
Queries the current channel.
Parameter
Name
Type
Range
Default
{CH1|CH2}
Discrete
CH1|CH2
CH1
Return Format
The query returns CH1 or CH2.