Rigol DG822 - Page 71

Chapter 2 Command System RIGOL
DG800 Programming Guide 2-57
<amp>
Real
Refer to "Remarks".
5 Vpp
<offset>
Real
Refer to "Remarks".
0 V
dc
<phase>
Real
0° to 360°
0°
Remarks
 When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
 The range of <amp> is limited by the "Impedance" (
:OUTPut[<n>]:IMPedance
or
:OUTPut[<n>]:LOAD) and "Frequency/Period" settings. The range of <offset> is limited by the
"Impedance" and "Amplitude/High Level" settings.
Example
:SOUR1:APPL:SIN 100,3,2,1 /*Sets the waveform of CH1 to Sine with 100 Hz frequency, 3 Vpp
amplitude, 2 V
dc
offset, and 1° start phase.*/
[:SOURce[<n>]]:APPLy:SQUare
Syntax
[:SOURce[<n>]]:APPLy:SQUare
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum[,<offset>|DEFault|MINimu
m|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Sets the waveform of the specified channel to Square with the specified frequency, amplitude, offset, and
phase.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<freq>
Real
1 μHz to 10 MHz
1 kHz
<amp>
Real
Refer to "Remarks".
5 Vpp
<offset>
Real
Refer to "Remarks".
0 V
dc
<phase>
Real
0° to 360°
0°
Remarks
 When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related parameters of CH1 by default.
 The range of <amp> is limited by the "Impedance" (
:OUTPut[<n>]:IMPedance
or
:OUTPut[<n>]:LOAD) and "Frequency/Period" settings. The range of <offset> is limited by the
"Impedance" and "Amplitude/High Level" settings.
Example
:SOUR1:APPL:SQU 100,1,2,3 /*Sets the waveform of CH1 to Square with 100 Hz frequency, 1 Vpp
amplitude, 2 V
dc
offset, and 3° start phase.*/
[:SOURce[<n>]]:APPLy:USER
Syntax
[:SOURce[<n>]]:APPLy:USER
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum[,<offset>|DEFault|MINimu
m|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Sets the waveform of the specified channel to Arbitrary with the specified frequency, amplitude, offset, and
phase.