- 5 -
Therefore, you are recommended to add one ground wire to the
signal line of each channel and twist them, and the ground wire
should be as close as possible to the corresponding signal line.
Method 2: on the basis of Method 1, you can connect a grabber
to each lead and connect it to the device under test as shown in
Figure 2.
Figure 2
3
． Set the probe: press LA on the front panel of the oscilloscope to
enter the digital channel setting menu. Users can view and set the
following parameters under this menu: threshold level (the threshold
levels of D7-D0 and D15-D8 can be adjusted independently),
waveform size (applicable to all the channels; wherein, Large is only
To Next Page
Loading...
