EasyManua.ls Logo

RIKA Memo - Stopping During Ignit or Startphase; EASY 40 - Operation; Cleaning and Tipping During Operation; EASY 40 - Switch Off

RIKA Memo
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
|
15
EN
14
key display description
EASY OFF
IGNIT
START
EASY 35
Pressing
starts the unit.
This is shown by IGNITE in the display; this is
replaced by START after a brief time.
EASY xx appears in the display after the
start phase (xx stands for a value between
30% and 100%, depending on output)
to c hang e the power setting
press „ + or „ -“ k eay ( the setting will b e c hang ed in 5 % steps
sing le press
EASY
EASY
O FF
IGNIT
START
50
Stopping during ignit or startphase
If switching off occurs again 50 sec. within switching on ( -key) (at least 2
sec.
-key), the pellet stove returns to inactive status.
If switching off occurs during the ignition process (IGNIT or START) (at least 2
sec.
-key), IGNIT OFF or START OFF appears in the display and the burn-out
phase is initiated. The pellet support stops - the flue gas fan continues to burn
any pellet residues (approximately 10 minutes). The stove changes to EASY
OFF.
EASY 40 – operation
key display description
EASY 40
Standard display for stove switched on in
simple heating mode. (40 is the output in %)
EASY 45 Pressing increases output by 5%
EASY 40 Pressing decreases output by 5%
Cleaning and tipping during operation
The automatic cleaning process is conducted every hour for approx. 2 minutes.
During this phase the air vents that are necessary for combustion are blown
clean.
The pellet stove enters the burnout phase every 7 hours. A tipping process is
conducted automatically. The start-up phase is automatically re-initiated after
completion of the burnout phase and operation continues
EASY 40 – switch off
key display description
STOP
EASY OFF
The burnout phase is initiated by pressing for
at least 2 seconds (until the change is visible
on the display). The pellet support stops -
the flue gas fan continues to burn any pellet
residues (approximately 10 minutes).
The stove changes to EASY OFF.
c hang e power setting b y
pressing the „ + or „ -“ k ey
( c hang e in 5 % inc rem ents)
sing le press
pressing the b utton
( until the c hang e is visib le
on the display)
EASY
EASY
O FF
IGNIT
START
50

Table of Contents

Other manuals for RIKA Memo

Related product manuals