22
11. CLEANING
Depending on pellet consumption, a message prompting cleaning of
the stove appears on the display in regular intervals� This message
can be acknowledged on the Touch Display, while continuing
operation� Perform a cleaning cycle at the next opportunity�
Subsequently, reset the counter in the SETTINGS menu / RESETS
submenu, as per operating instructions of TOUCH DISPLAY�
Tip
The message will only stop reappearing once you have reset the
feed volume in the SETTINGS / RESETS menu�
Note
Your stove must be switched off and cooled before any cleaning
work is performed� Only work on the unit when the mains plug has
been disconnected�
Cleaning the convection air openings
Vacuum clean any dust deposits from the convection air openings
at regular intervals�
The stove should be cleaned thoroughly prior to the start of the
heating season to prevent excess odour�
Note
To prevent your stove from overheating of the internal components,
do never cover the convection fins!
Combustion air - intake
If necessary, please also clean the air intake with a hoover�
Note
Only when the stove is cold! You could vacuum out embers – FIRE
RISK!
Cleaning the pellet container
Do not refill the completely empty container immediately; remove
the residues (dust, chippings etc�) from the empty container� The unit
must be disconnected from the mains!
Cleaning flue pipes PARO and PARO
MultiAir
The flues are lateral the combustion chamber�
Preparation PARO
Open the combustion chamber door and lift the convection fins
carefully up�
Now loosen the two wing screws and remove the side panel�
Preparation PARO MultiAir
Open the combustion chamber door and lift the convection fins
carefully up�
Now loosen the two knurled screws and remove the side panel�
Remove the cleaning lid beneath the fan�
Images for cleaning using the example Paro
To Next Page
Loading...
