12
6. ASSEMBLY/DISMANTLING STONE AND OPTIONS
Note
Only work on the unit when the mains plug has been disconnected and the
stove has cooled down completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to fall into
the pellet container – they can block the screw conveyor and damage the
stove.
Note
During any conversion work, take particular care of your fingers and any
panels and stove attachments.
Select soft bases to prevent scratches to your living space furniture and
stove panels.
Dismantling stone
Loosen the 4 Allen screws and slide the confection fins to the right.
You can pick up the confection fins now.
Open the pellet container lid until it stops, in this position, it stays open.
Remove the self-locking hex nut including the cover plate which is used to seal
the pellet hopper.
Remove the two hex nuts including washers.
Now you can lift up the top stone with caution.
The side metal casing is secured with 2 hex screws. Incline the side panels
slightly and lift them up.
#3
#10
#10
#8
To Next Page
Loading...
