Cleaning the flame temperature sensor
Remove the dust deposits from the sensor at regular intervals. Use a clean
cleaning cloth or newspaper.
Cleaning the pellet container
Do not refill the completely empty container immediately; remove the residues
(dust, chippings etc.) from the empty container. The unit must be disconnected
from the mains!
Bearings
all built in bearings ( Pellet screw or turning Grid ) should be checked and
cleaned according to the condition or replaced min. once per Year.
Checking door seal
The condition of the seals at doors and glass should be checked at least 1 x per
year. Repair or replace seals depending on condition.
Note
Only intact seals ensure your stove works perfectly.
Cleaning of painted surfaces
Wipe of the painted surfaces with a damp cloth, do not scrub. Do not use
solvent-containing cleaners.
Cleaning the flue gas channels
(1 x annually)
Remove the flue pipes. Inspect and clean chimney connection. Brush off any
soot and dust deposits in the fire and in the flue pipes and vacuum.
Note
Accumulated fly ash in the flue gas channels may impair the performance of
the stove and pose a safety risk.
To Next Page
Loading...
