Riken Keiki GP-1000 - User Manual

Questions and Answers

M
Miguel GonzalezAug 1, 2025
What to do if Riken Keiki GP-1000 show FAIL - LOW FLOW?
- K
  Kevin BeanAug 1, 2025
  If your Riken Keiki Gas Detectors display 'FAIL - LOW FLOW', this indicates a low flow rate. This can happen due to clogs, a bended hose, or pump failure. First, check for and eliminate any clogs or bending in the sampling part or hose. Then, press the RESET button. If the pump has failed, or the unit was stored for a long time without being used (6 months or longer), request RIKEN KEIKI to replace the pump. If the unit was stored for a long time, try turning it off and on again several times.
C
Christopher GoodmanAug 5, 2025
What to do if Riken Keiki Gas Detectors show FAIL - BATTERY?
- L
  Linda AustinAug 5, 2025
  If your Riken Keiki Gas Detectors display 'FAIL - BATTERY', it means the battery level is low. Turn off the power and replace the batteries with new ones.
S
Scott DiazAug 9, 2025
Why is the reading rising and remaining high on Riken Keiki GP-1000?
- K
  kenneth96Aug 9, 2025
  If your Riken Keiki Gas Detectors are showing abnormal readings that rise and remain high, there could be a couple of reasons. It could be due to drifting of the sensor output, in which case you should perform zero adjustment. Alternatively, a high-concentration combustible gas may have been drawn in. In this case, supply fresh air and let the unit sit for a while.
L
lewislauraAug 14, 2025
What does FAIL - SENSOR mean on Riken Keiki GP-1000?
- A
  Amanda MooreAug 14, 2025
  If your Riken Keiki Gas Detectors display 'FAIL - SENSOR', it indicates that a sensor has failed. Request RIKEN KEIKI to replace the sensor.
B
Bonnie CastilloAug 18, 2025
Why is zero adjustment failing on Riken Keiki Gas Detectors?
- D
  Diane PottsAug 18, 2025
  If your Riken Keiki Gas Detectors are failing zero adjustment, it could be because the surrounding air wasn't fresh during the adjustment. Press the RESET button to reset the alarm, supply fresh air, and then perform the zero adjustment again.
A
Angela SchneiderAug 22, 2025
What does FAIL - SYS*** mean on Riken Keiki Gas Detectors?
- A
  amymatthewsAug 22, 2025
  If your Riken Keiki Gas Detectors display 'FAIL - SYS***', this indicates a circuit abnormality. Record the display content "FAIL - SYS***" and then contact RIKEN KEIKI for repair.
T
Timothy BishopAug 27, 2025
What does FAIL - CLOCK mean on Riken Keiki GP-1000 Gas Detectors?
- M
  michael70Aug 27, 2025
  If your Riken Keiki Gas Detectors display 'FAIL - CLOCK', the clock function has failed. Request RIKEN KEIKI for repair.