Need help?Do you have a question about the ring 3 Plus and is the answer not in the manual?
General| Video Resolution | 1080p HD |
|---|---|
| Power Source | Rechargeable battery or wired |
| Field of View | 160 degrees |
| Connectivity | 2.4GHz Wi-Fi |
| Two-Way Talk | Yes |
| Night Vision | Yes |
| Motion Detection | Yes (adjustable motion zones) |
| Operating Temperature | -5°F to 120°F (-20°C to 50°C) |
| Weather Resistance | Yes |
| Compatibility | Alexa |
Charge the battery by plugging it into a power source using the provided orange cable until the light turns green.
After charging, insert the battery into the bottom of the Video Doorbell until it clicks into place.
Download the Ring app and follow in-app instructions to set up your device near your Wi-Fi router.
Push the front button after setup to view live video from the camera in the Ring app.
Install the Video Doorbell approximately four feet above the ground for optimal performance and detection.
Detailed steps for wiring the doorbell, including removing the old unit and connecting wires.
If replacing, shut off power at the breaker, then remove and disconnect the old doorbell.
Configure chime settings for 'No In-Home Chime' or existing chimes, or consider a Ring Chime.
Insert the mini-level into the Video Doorbell to ensure it is installed evenly.
For masonry, mark, drill holes, and insert anchors for secure mounting.
Connect wall wires to the back of the Video Doorbell; the order of wires does not matter.
Use provided wire extensions and nuts if connecting wires coming out of the wall is difficult.
Feed wires into the wall and secure the Video Doorbell to the wall using four screws.
Place a faceplate onto the doorbell, then secure it with a provided security screw.
To Next Page
