To Next PageTo Next Page
Need help?Do you have a question about the Rinnai c199i and is the answer not in the manual?
General| Type | Tankless |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Minimum BTU Input | 15, 000 BTU |
| Electrical Requirements | 120V |
| Ignition Type | Electronic |
| Warranty | 12 years heat exchanger, 5 years parts |
| Maximum BTU Input | 199, 000 BTU/h |
Skills and training required for licensed professionals performing installation.
Mandatory DO NOTs and MUST DOs for proper installation compliance and safety.
Evaluation of water quality parameters to prevent heat exchanger damage.
Assessing the environment for corrosive compounds affecting combustion air.
Definition and requirements for unconfined spaces for combustion air intake.
Definition and requirements for confined spaces for combustion air intake.
Proper positioning of openings for combustion air circulation in confined spaces.
Guidelines for using indoor air for combustion, including volume and opening requirements.
A checklist to verify proper combustion air and venting installation.
Specific guidelines and restrictions for C199i vent termination locations.
Specific guidelines and restrictions for C199e vent termination locations.
Important factors for locating vent outlets and avoiding recirculation of flue gases.
Methods for calculating total equivalent vent length using components and tables.
Guidelines for securely fastening vent piping and sealing penetrations.
Instructions for installing the IPEX Concentric Vent Kit, including clearances.
Instructions for mechanically fastening the rain cap with screws.
Step-by-step sequence for installing the vent system.
Clearances and piping placement for multiple water heaters installed through the roof.
Step-by-step guide for proper cementing of PVC/CPVC joints.
Checklist to verify proper venting and condensate handling for indoor models.
Guidelines for selecting and installing approved pressure relief valves.
Recommendation for installing isolation valves for easier servicing and flushing.
Requirements for potable water system components, purging lines, and water quality.
Recommended annual manual operation and safety precautions for the PRV.
Checklist to verify proper plumbing installation, including purging, leaks, and water pressure.
Warning and general instructions for the safe installation of the gas supply.
Instructions for adjusting DIP switches for high altitude installations.
Instructions for adjusting SW 1 in DIPSW 1 for vent length.
Checklist to verify proper gas and electrical installation and connections.
Information on wiring multiple temperature controllers in parallel.
Recommendations for optimal placement of the temperature controller.
Guidelines for selecting appropriate cable lengths and gauges for temperature controllers.
Immediate steps to take if a gas leak is detected.
Detailed steps for turning the water heater on and setting the temperature.
Procedure for safely turning off the gas supply to the appliance.
Information on how to display and interpret diagnostic codes for troubleshooting.
Steps for cleaning internal components, burners, and air passageways.
Annual inspection of the vent system for blockages or damage.
Information on motor lubrication and cleaning.
Instructions for cleaning the temperature controller.
Addressing scale build-up and its impact on the heat exchanger.
Ensuring vent terminals are clear of snow and ice for proper airflow.
Additional maintenance requirements for installations in coastal areas.
Procedure for cleaning the water inlet filter.
Guidelines for visually inspecting the burner flame for proper operation.
Recommendations for preventing freezing of the water heater and lines.
Recommendations for winterizing the water heater, including gas, water, electric, and vent.
List of conditions and circumstances not covered by the limited warranty.
