You Will Need
• Module (supplied)
• 2 wall anchors and 2 screws (supplied)
• Tools (field-supplied): Phillips head screwdriver, drill with
bit set, level and pencil
The module’s back panel contains two keyhole slots
that support the module. Mark the location of each
slot on the wall with a pencil. The distance between
the two slots is 1.9 in. (48 mm).
Use a level to ensure the slots are even.
Use a power drill to drill pilot holes for the module
screws and anchors.
1.9 in.
(48 mm)
❶
❷
To Next Page
Loading...
