Rinnai Control-R Installation Instructions

1. Using a Phillips screwdriver, remove the screw located on the center of the Moon Sensor. Remove the front cover.
2. Insert the baery.
 Prior to installaon, determine the best locaon for the Moon Sensor. Rinnai recommends installing the Moon Sensor near
a water xture that will have a great deal of use. A site survey is recommended prior to installaon.
 The Moon Sensor detects full body movement up to 39 feet and limb movement up to 16 feet away from the sensor. The
sensing angle is 110°.
 The Moon Sensor should be corner mounted on a wall between 6 to 9 feet above oor level and in an area with a clear line
of sight to the space.
 The Moon Sensor provides a wireless transmission of data to Rinnai’s Control-R™ Module. The Control-R™ Module must be
installed and funconing properly before installing the Moon Sensor. The Moon Sensor must not be mounted behind any
obstrucng objects that could harm the wireless signal strength.
 Make sure to install the Moon Sensor in the correct orientaon (see below):
IMPORTANT: Read the Installaon Requirements secon above prior to installing the Moon Sensor.
You Will Need:
 Moon Sensor
 Control-R™ Module
 Phillips screwdriver (customer-supplied)
Control-R™ Motion Sensor Installation Instructions
Instrucons
Installaon Requirements
Part #
RWMMS01
Package Contents
A. Moon Sensor
B. Wall Mounng Bracket
C. Wall Posioning Joint
D. Baery*
* The Moon Sensor uses a 3.7V
2600mAh AA size Lithium-Thionyl
Chloride baery; the baery is not
rechargeable. Baery life is up to 1.5
years, depending on transmission
intervals.
This document provides instrucons on installing the Rinnai Control-R™ Moon Sensor.
The Control-R™ Moon Sensor works with the Control-R™ Module to operate the Rinnai Tankless Water Heater recirculaon
system. The Moon Sensor mounts near the point of use (such as a kitchen faucet or bathroom sink) and acvates the recirculaon
system with the detecon of moon. The recirculaon system will deacvate aer ve minutes from iniaon or when the water
has reached the set temperature. The Moon Sensor is only compable with Rinnai Tankless Water Heaters featuring Rinnai
Circ-Logic™. Follow all instrucons carefully to ensure proper performance.
A B C D
NOTE: If the recirculang pump has recently been acve and the recirculaon loop is sll warm, there may be a delay in pump
acvaon. To minimize any delay in pump acvaon, set the Rinnai Tankless Water Heater to Comfort Mode. Refer to the
“Recirculaon Mode” secon in the Tankless Water Heater Installaon and Operaon Manual for more informaon on Comfort
Mode.

Rinnai Control-R Specifications

General

Connectivity	Wi-Fi
Wireless Standard	IEEE 802.11 b/g/n
Frequency Band	2.4 GHz
Compatibility	Rinnai tankless water heaters
Functionality	Remote control and monitoring
Security	WPA2
Operating Range	Up to 100 feet (depending on environment)