What to do if my Rinnai Inverter is not working?
If your Rinnai Inverter isn't working, first, wait for the power to be restored in case of a power failure. If the power is off, turn it on. Check and replace the fuse if it's burned out. Replace the remote control batteries if they are dead. If the unit’s 3-minute protection has been activated, wait three minutes after restarting it. Finally, ensure the timer is turned off.
How to improve the cooling performance of my Rinnai DONSR18B1 Inverter?
If your Rinnai Inverter has poor cooling performance, try the following: Lower the temperature setting if it is higher than the room temperature. Clean the heat exchanger if it is dirty. Clean the air filter after removing it. If there is a blockage of the air inlet or outlet, turn the unit off, remove the obstruction, and turn it back on. Ensure all doors and windows are closed. Close windows and curtains to reduce excessive heat from sunlight. Reduce the amount of heat sources in the room.
Why does my Rinnai Inverter start and stop frequently?
If your Rinnai Inverter starts and stops frequently, it could be due to several reasons. The system may have too much or too little refrigerant, so check for leaks and recharge the system. There might be air or foreign material in the refrigeration system, in which case you should evacuate and recharge it. A blocked system circuit could also be the cause, requiring you to determine which circuit is blocked and replace the malfunctioning component. The compressor might be broken and need replacement. Lastly, the voltage could be too high or too low, and you may need to install a manostat to regulate it.
How to troubleshoot poor heating performance in my Rinnai DONSR18B1?
If your Rinnai Inverter has poor heating performance, especially when the outdoor temperature is extremely low, check for leaks and recharge the system with refrigerant. Ensure all doors and windows are closed to prevent cold air from entering. Also, low refrigerant levels due to leaks or long-term use can cause this issue; in that case, check for leaks, re-seal if necessary, and top off the refrigerant.
General| Type | Split System Air Conditioner |
|---|---|
| Model | DONSR18B1 |
| Cooling Capacity (BTU/h) | 18, 000 |
| Refrigerant | R410A |
| Indoor Unit Net Weight | 24.3 lbs |
| Outdoor Unit Net Weight | 34 kg |
| Outdoor Unit Dimensions (HxWxD) | 31.5" x 12.6" |
| Operating Temperature (Cooling) | 5°F to 122°F |
To Next Page
