Rinnai E- Series User Manual

44 008082013GW
T5 sensor is reading too high of a flue gas temperature. (Adjust
parameter 84 – default 212 ⁰F) See location of T5 sensor below. If red
cap is installed, T5 sensor is not being used.
T5 Senor, if
installed
Moisture on the flue gas sensor wires or
terminals could cause a false temperature
reading.
WARNING:
Turn off power and water
s
upply
to the boiler before removing or installing any parts

Rinnai E- Series Specifications

General

Fuel Type	Natural Gas or Propane
Installation	Wall-mounted
Type	Condensing
Venting	Direct Vent
Dimensions	Varies by model
Weight	Varies by model
Warranty	12 years heat exchanger, 5 years parts
Heating Capacity	15, 000 - 199, 000 BTU/h
Vent Type	Direct Vent