Rinnai 1 HW_CF_PC_IM
PIPE COVER INSTALLATION MANUAL
GENERAL INFORMATION
When a pipe cover is installed it will conceal 400mm of pipework. For longer pipe runs, pipe covers can be joined to
one another, with each additional pipe cover extending the amount of concealment by a further 400mm.
The pipe covers in this manual are designed to t specic Rinnai Continuous Flow Water Heater models. Ensure the
correct pipe cover is being installed by conrming the model number against that found on the appliance data plate.
PC 11 / PC11D
*
PCV01
Innity 26 REU-VR2626WG
†
Innity 26i REU-VRM2632FFUG
Innity 20 REU-VR2024WG
†
HD 200i REU-VRM2632FFUC
#
Innity 16 REU-VR1620WG
†
HD200e REU-VRM2632WC
#
Innity 26 REU-VRM2626WG
†
PCV02
Innity 20 REU-VRM2024WG
†
Innity 32 REU-VR3237WG
Innity 16 REU-VRM1620WG
†
Innity 32 REU-VRM3237WG
B26 REU-A2626WB & REU-VR2626WB
*
HD 250e REU-VRM3237WC
#
B20 REU-A2024WB & REU-VR2024WB
*
Innity 26 Smartstart REU-V2626WGP
B16 REU-A1620WB & REU-VR1620WB
*
Innity 26 Smartstart REU-VR2626WGP
S26 REU-A2626WS & REU-VR2426WS
*
PCK01
S20 REU-A1620WS & REU-VR1620WS
*
ENVIROSMART REU-K2430WG
*
PC11D = Dune colour, all other water heater models are white.
#
Pipe cover is not available in the HD water heater model colour.
†
Installations may require additional drilling and xings.
INSTALLATION METHOD
1. Install water heater and connections, then remove screws (A) from the lower side panels of the water heater.
For models where the casing screws are not tted, refer to "Installation Method - Installer
Supplied Casing Screws" on page 2.
2. With the pipe cover held in the installed position, mark the location of the wall bracket securing holes (B).
3. Secure the wall bracket with suitable xings at the location marked in step 2.
4. Secure pipe cover to water heater with the screws (A) removed in step 2
5. Secure pipe cover to wall bracket (C) with screws provided, use elongated holes to keep components square.
6. Fit the front panel to complete the installation.
A
C
A
B
To Next Page
Need help?
General
