Need help?Do you have a question about the Rinnai Sensei RU160i and is the answer not in the manual?
General| Max Input Rate | 160, 000 BTU/h |
|---|---|
| Minimum BTU Input | 15, 000 BTU/h |
| Energy Factor | 0.82 |
| Minimum Flow Rate | 0.5 GPM |
| Temperature Range | 98°F to 140°F |
| Ignition Type | Electronic |
| Fuel Type | Natural Gas |
| Venting | Direct Vent |
| Vent Size | 3" |
| Electrical Requirements | 120V, 60Hz |
| Warranty | 5 years on parts |
| Category | Tankless Water Heater |
| Temperature Range with MCC-91 controller | 98°F to 160°F |
Explains hazard alert symbols used in the manual to indicate potential risks.
Describes the process of replacing the gas orifice to match the new gas type.
Details how to modify the appliance's settings to optimize for the converted gas type.
Guides on verifying the correct and safe operation of the water heater after conversion.
Provides instructions for safe and proper operation of the converted appliance.
To Next Page
