To Next PageTo Next PageWhat to do if my Rinnai Water Heater starts then shuts down immediately?
If your Rinnai Water Heater starts and then shuts down immediately, ensure the power is still on. Also, check that the gas isolation valves at the unit and the gas meter are fully open. Finally, make sure to open your hot water tap fully.
What to do if my Rinnai V1200 has no ignition or gas supply?
If your Rinnai Water Heater has no ignition or gas supply, check that the gas is turned on at both the water heater and the gas meter or cylinder.
What to do if my Rinnai V1200 Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water goes cold, verify that the power is still on. Additionally, try opening your hot water tap further.
What to do if my Rinnai Water Heater does not attempt to start at all?
If your Rinnai Water Heater does not attempt to start at all, check that the power is on at the unit. Also, ensure that the isolation valves at the unit are open.
What to do if there is power interruption during bath fill with my Rinnai V1200?
If you experience a power interruption during a bath fill and the water will not flow when the power is restored, turn off all hot water taps. Then, press the On/Off button twice.
Why is there flame failure or low gas flow in my Rinnai V1200 Water Heater?
Flame failure or low gas flow in your Rinnai Water Heater may occur if the gas is not turned on at the water heater, gas meter, or cylinder. Another possible cause is obstructions to the flue outlet, so check for those as well.
How to fix a noticeable reduction in water flow in Rinnai V1200?
A noticeable reduction in water flow in your Rinnai Water Heater might be because the inlet water filter needs cleaning. A service call is recommended.
General| Brand | Rinnai |
|---|---|
| Model | V1200 |
| Category | Water Heater |
| Language | English |
Details the features and components of the Universal Water Controller (MC-91Q).
Instructions on how to switch on the Universal Water Controller and prepare it for operation.
Guide on how to select and adjust the desired water temperature using the controller.
Instructions on activating multiple Universal Water Controllers before use.
Details the process of transferring control priority between connected Universal Water Controllers.
Guide on setting water temperature when multiple controllers are active.
Details the features and components of the Deluxe Bathroom Water Controller (BC-100V).
Instructions on how to switch on the Deluxe Bathroom Water Controller and prepare it for operation.
Default temperature and volume settings for the Shower Saver / Bath Fill function.
Steps to customize temperature and water volume for the Shower Saver / Bath Fill feature.
Details the features and components of the Deluxe Kitchen Water Controller (MC-100V).
Instructions on how to switch on the Deluxe Kitchen Water Controller and prepare it for operation.
Guide on adjusting audible settings and voice prompts for the Deluxe Kitchen controller.
Specifies installation requirements according to AS/NZS3000, AS/NZS3500, AS5601, and local codes.
Lists the Rinnai Continuous Flow water heater models covered by these installation instructions.
Provides guidance on suitable locations for both external and internal model installations.
Highlights key factors for installing the condensate drain pipe, including material and discharge points.
Specifies maximum lengths and allowed changes in direction for condensate drain lines.
Provides detailed installation steps and restrictions for condensate drain lines.
Introduces Rinnai's Universal and Deluxe water controllers and their compatibility.
Guidance on optimal placement of water controllers for functionality and safety.
Details about the electrical cables used for connecting water controllers to the heater.
Step-by-step instructions for mounting and connecting the Universal Water Control (MC-91Q).
Outlines the procedures for testing all functions after installation to ensure correct operation.
Information regarding the gas pressure regulator and when adjustments might be necessary.
A checklist to guide installers through the final commissioning steps and identify potential errors.
