Rinstrum R323 - CLOC (Clock) - K35; TEST (Special Test Functions)

Reference Manual V1.19 Software Versions 4.xx
Page 40 003R-682-119
8.4.8. CLOC (Clock) – K35*
CLOCK (Clock Settings) Items within this group set date and time related functions.
D.FMT (Date Format)
This sets the date format.
Options:
DD.MM.Y4
DD.MM.Y2
MM.DD.Y4
MM.DD.Y2
Y4.MM.DD
Y2.MM.DD
Default: DD.MM.Y4
T.FMT (Time Format)
This sets the time format.
Options:
HH.MM, HH.MM.SS
Default: HH.MM
T.MODE (Time Mode)
This sets the time mode.
Options:
24HOUR. 12HOUR
Default: 24HOUR
YEAR (Set Year)
Range: 2000 to 2099
MONTH (Set Month)
Range: 01 to 12
DAY (Set Day)
Range: 01 to 31
HOUR (Set Hour)
Range: 00 to 23 (24-hour format)
MINUTE (Set Minute)
Range: 00 to 59
QA.OPT (Quality
Assurance Feature)
Turn the quality assurance feature on or off.
Options: ON, OFF
Default: OFF
QA.YEAR (Set Year
for QA)
Set year for quality assurance.
Range: 2000 to 2099
QA.MONTH (Set
Month for QA)
Set month for quality assurance.
Range: 01 to 12
QA.DAY (Set Day for
QA)
Set day for quality assurance.
Range: 01 to 31
8.4.9. TEST (Special Test Functions)
Items within this Group allow access to the testing routines for the instrument. With these
routines, the scale base output can be monitored and the inputs and outputs can be tested.
SCALE (Scale Base
Test Display)
Verifies the correct load cell capacity and/or load cell wiring is used. It
sets up the instrument as a simple test meter to measure the load cell
signal output. The display reads in millivolts per volt, factory calibrated to
0.1% worst case. When accessing this item, initially there should be no
weight on the scale. In OIML or NTEP modes, this display is only active
for five seconds before returning to the menu.