Rio GO - CHANGING THE SECURITY CODE SEQUENCE

28
CHANGING THE SECURITY CODE SEQUENCE
You can set your own security code once you have unlocked the unit with the security key and entered the security
sequence. BEFORE pressing any other buttons, press these buttons in the following order;
treatment button 3 times, scan mode 3 times, single hair mode 3 times and treatment button 3 times.
The power level 5 light will flash.
Enter your chosen security code sequence of four button presses (excluding the treatment button). Each button
press will be indicated on power levels 1 to 4. All five power level lights will flash 3 times to confirm your security
code has been accepted. Make a note of your security code for future reference.
If your chosen security code is not entered within 20 seconds or the treatment button is pressed, the unit will
‘lockout’. This is indicated by all five power levels flashing. Your security code will not be saved.
To restart turn the security key off/on and then re-enter the original security sequence.
© Copyright The Dezac Group Ltd. 2014