To Next PageTo Next Page
Need help?Do you have a question about the Ripmax Bolero and is the answer not in the manual?
General| Servos | 4 x 9g |
|---|---|
| Construction | EPO Foam |
| Motor | Brushless Outrunner |
| ESC | 40A |
| Battery | 3S LiPo |
| Radio | 4 Channel |
Wingspan, length, radio channel requirements, and servo size.
Recommended brushless motor, ESC, and Li-Po battery for electric power.
Recommended engine sizes for 2-stroke and 4-stroke, and flying weight.
Covers general safety, dangers of propellers, heat, tools, adhesives, and batteries.
Essential checks before flying the model for safe operation.
Rules for safe and proper operation of the model, including flying locations.
Transmitter antenna placement, model insurance, and liability disclaimers.
Overview of the Ripmax Bolero ARTF funfly model and assembly.
List of components and tools needed for assembly.
Attaching ailerons and servos to the wings using hinges and pushrods.
Installing elevator and rudder servos and control surfaces.
Connecting servos to control surfaces via pushrods and horns.
Steps for installing the electric motor, ESC, and related components.
Steps for installing the internal combustion engine and mount.
Installing the fuel tank and connecting the throttle linkage.
Attaching wings, canopy, radio switch, and other final components.
Attaching aerodynamic aids for enhanced maneuverability.
Applying the supplied decals to the finished aircraft.
Recommended control surface throws for initial flights and aerobatics.
Setting the correct balance point for stable and safe flight.
Final checks, advice on flying the Bolero, and its capabilities.
Details on how to obtain replacement parts from Ripmax stockists.
