Page / Seite 4
Congratulations on your purchase of the Mini Xcalibur E Jet. The Mini Xcalibur E takes all of the
best flying characteristics from its bigger counterparts and incorporates them into a compact and
practical package. This high performance model is ideal for use as a first EDF or as a sports EDF
model and is practical to store and transport.
Before you build your model, please read the instructions the whole way through to fully understand
the construction sequence. You will need to refer to the manufacturer of your EDF power system and
radio control system as some steps might vary with different equipment.
The Mini Xcalibur E has been designed specifically for use with 90mm EDF units such as the
Wemotec Midi Fan. Different manufacturers of 90mm fan units will have different dimensions and
performance capabilities so modifications may be needed for optimal use.
• 90mm EDF unit such as the Wemotec Midi Fan.
• 8S brushless motors & suitable speed controller.
• 2 x 4S Hi-Energy 4500mAh.
• Suitable radio system of at least 7 channels.
• Battery pack of at least 1000mAh capacity for the
radio system.
• We suggest using Quartz servos as used in our
prototypes and these instructions.
• 5 Mini servos of at least 3Kg/cm torque, (Quartz
QZ204 Recommended)
• 1 Mini side mount servo of at least 5Kg/cm torque,
(Quartz QZ201 Recommended)
• Various extension leads for rudder, elevator, aileron
and flap servos.
• Various tools, glues and materials
Introduction
Required to Complete
To Next Page
Loading...
