Risco RisControl - Page 2

2
Introduction
The RisControl can be used in 3 operation modes, as follows:
• Smart Home + Security – For Security, RisControl is connected to a
control panel via the RS-485 bus. For Smart Home operation,
RisControl is connected to RISCO Cloud via Wi-Fi. If there are
additional RisControl units, a Master / Slave configuration should be
defined.
• Smart Home Only– RisControl is connected to the RISCO Cloud via
Wi-Fi (no BUS connection to the RISCO control panel). In addition,
if there are more RisControl units in the installtion, a Master / Slave
configuration should be defined.
• Security Only- RisControl is connected to a control panel via the
RS-485 bus and to the RISCO Cloud via Wi-Fi