29
Step 7 – Setting Communication between RisControl
and the Control Panel
Note: This step is relevant when the RisControl is connected to a control panel
(Smart Home + Security or Security Only operation modes). For Smart
Home Only operation mode, skip to the next step.
Enter the panel’s RISCO Cloud password and then enter it again to confirm.
This ends the setup procedure for the Master Smart Home Gateway.
Note: The panel’s password is used by the RISCO Cloud for validating its
communication with the security system in the site and is required in order to add the
panel to the selected or created site. The default password for the new panel is “AAAAA”.
To Next Page
Loading...
