Risco RVCM11H User Manual

16
2. Once the Camera Interface Login page is displayed, enter the User and
Password into the relevant fields and click Login.
NOTE – By Default the User and Password for camera login is “admin” and
“_AdmiN_+ camera MAC address” (e.g._AdmiN_AABBCCDDEEFF).
1. Once the Camera Interface page is displayed, select Setup > Network >
UPnP. The UPnP Parameters page is displayed.
Figure 18 UPnP Parameters
2. Uncheck the UPnP Enable option and click Save.
3. Select TCP/IP. The TCP/IP Parameters page is displayed.
Figure 19 TCP/IP Parameters
4. Select the Static Mode option and enter the static IP address you want to
set for the camera (in our example 192.168.1.122). Also set the subnet
mask and Default gateway address (in our example 255.255.255.0 and
192.168.1.1).

Risco RVCM11H Specifications

General

Brand	Risco
Model	RVCM11H
Category	IP Camera
Language	English