Risco RVCM52E - Powering-Up the IP Camera; Connecting the IP Camera to the Network; Connecting to a LAN Network

6
Powering-up the IP Camera
Connect the camera power adapter to an electrical outlet.
Connecting the IP Camera to the Network
The IP camera supports a LAN network connection.
Connecting to a LAN Network
Connecting the IP camera to a network using the LAN (Local Area Network)
enables easy connection and setup with compatible APs (Access Points), e.g.
gateway or router.
1. Connect the incoming network cable to the Network port on the IP camera.
2. Wait just a few minutes while the IP camera automatically connects to the
RISCO Cloud.
3. Define the IP camera settings (Refer to Defining IP Camera Settings).