What to do if Riso EZ5 All in One Printer can not identify USB flash drive?
If your Riso All in One Printer cannot identify the connected device, ensure you are using a USB Flash Drive specifically designed for this machine.
What to do if Riso All in One Printer shows system error (press reset key)?
If your Riso All in One Printer displays a system error, try pressing the key. If the problem continues after this, it indicates a persistent system error.
What to do if master is jammed in disposal unit of Riso EZ5?
If the master is jammed in the Master Disposal Unit of your Riso All in One Printer: * Pull out the Master Disposal Box and remove the jammed master. * If the masters are difficult to remove, pull out the Print Drum (Cylinder) and then remove.
What to do if Riso All in One Printer shows system error (turn main power SW off)?
If your Riso All in One Printer is displaying a system error, try turning the main power switch off and then restarting the printer. This may resolve the issue.
What to do if Riso EZ5 All in One Printer shows master disposal error?
If you receive a Master Disposal Error on your Riso All in One Printer, it means the master was not properly discarded. Resolve it by following these steps: 1. Pull out the Print Drum (Cylinder) and remove the master from the drum (cylinder). 2. Return the Print Drum (Cylinder) in place. 3. Press the key.
What to do if Riso All in One Printer has paper tape jam in job separator?
If your Riso All in One Printer has a paper tape jam in the Job Separator, check the Job Separator and remove the jammed tape.
What to do if Riso EZ5 has no paper tape in job separator?
If your Riso All in One Printer indicates that there is no paper tape in the Job Separator, load new tape into the Job Separator.
What to do if Riso All in One Printer has no toner in linked printer?
If your Riso All in One Printer indicates that there is no toner in the linked printer, replace the toner in the Linked Printer.
What to do if Riso All in One Printer has system error in master making unit?
If your Riso All in One Printer shows a system error in the Master Making Unit, it indicates that the cutter mechanism for the master malfunctioned. To resolve this, pull out the Master Making Unit and remove the master. Closing the Master Making Unit Cover will reset the error. Setup the master again.
What to do if my Riso All in One Printer has a system error (Main Power SW)?
If your Riso All in One Printer displays a system error, shut off the power and then restart the printer.
General| Type | Digital Duplicator |
|---|---|
| Image Modes | Text, Photo, Text/Photo |
| Resolution (print) | 300 x 300 dpi |
| Paper Weight | 46 - 210 g/m² |
| Interface | USB |
| Ink Type | RISO Ink |
To Next Page
