To Next PageTo Next Page
Need help?Do you have a question about the Rittal SK 3303. series and is the answer not in the manual?
General| Brand | Rittal |
|---|---|
| Model | SK 3303. series |
| Category | Air Conditioner |
| Language | English |
Details the different sets of instructions provided with the unit.
States the declaration of conformity is a separate document.
Emphasizes instructions are integral part of the product.
Explains safety and instructional symbols used throughout the manual.
Details how cooling units dissipate heat and protect enclosure components.
Details safety features like pressure switch and temperature monitoring.
Explains condensation formation and evaporation.
Discusses filter mat types and monitor function.
Describes the function and connection of a door limit switch.
Describes an interface card for monitoring systems.
Provides criteria for selecting an appropriate location for installation.
General steps and precautions for assembling the cooling unit.
Advice on component placement for optimal airflow and cooling.
Details the different methods for mounting the cooling unit.
Instructions for preparing the enclosure panel for mounting.
Specific steps for mounting the unit externally to the enclosure.
Guidance for installing the unit partially inside the enclosure.
Comprehensive steps for installing the unit fully inside the enclosure.
Instructions for properly routing the condensate drain.
Crucial guidelines for safe and compliant electrical connections.
Step-by-step guide for completing electrical wiring.
Last steps in assembly before initial startup.
How to correctly install air filter mats.
Attaching the display and louvred grille.
Configuring the filter monitoring function.
Operating the unit with the basic control interface.
Explains LED indicators and error codes for Basic controller.
Procedure to activate diagnostic test mode.
Guide to adjusting the unit's operating temperature.
Steps to reset the controller after fault rectification.
Operating the unit with the advanced Comfort control interface.
Details voltage support and features of the Comfort controller.
How to initiate test mode for the Comfort controller.
Overview of parameter adjustment and programming logic.
Lists configurable parameters and their settings.
Visual workflow for parameter configuration.
Configuring system messages for relay output.
Configuring network addresses for unit communication.
How to interpret system messages displayed on the controller.
Detailed troubleshooting guide for system messages.
Overview of the unit's low-maintenance design and general checks.
Instructions for cleaning components using compressed air.
Specific cut-out dimensions for external installation.
Specific cut-out dimensions for partial internal installation.
Specific cut-out dimensions for full internal installation.
