What does Hi-Temperature Delta Fault mean for Riverside Hydronics HeatStation HS 1000 Boiler?
If your Riverside Hydronics Boiler displays a Hi-Temperature Delta Fault, check the pump operation and confirm proper water flow across the heat exchanger.
How to fix Hi-Limit Fault on Riverside Hydronics HeatStation HS 1000 Boiler?
If your Riverside Hydronics Boiler displays a Hi-Limit Fault, check for proper water flow and inspect the hi-limit and outlet sensors.
What to do if Riverside Hydronics HeatStation HS 1000 Boiler shows Sensor Fault?
If your Riverside Hydronics Boiler has a Sensor Fault, refer to the digital control display to identify the specific fault. Then, inspect the sensors and their wiring.
How to troubleshoot Low Voltage Fault in Riverside Hydronics Boiler?
If your Riverside Hydronics Boiler shows a Low Voltage Fault, check the 24 VAC input voltage, ensuring it is above 18.0 VAC.
What causes Vent Temperature Fault in Riverside Hydronics Boiler?
If your Riverside Hydronics Boiler shows a Vent Temperature Fault, check for a blocked flue and inspect the vent sensor and its connections.
Why does Riverside Hydronics Boiler show False Flame Error?
If your Riverside Hydronics Boiler displays a False Flame Error, ensure proper gas valve closure and clean the burner and electrodes.
What to do if Riverside Hydronics Boiler has flame failure?
If your Riverside Hydronics Boiler experiences flame failure, ensure the unit receives 120 VAC for proper operation, investigating any voltage below 110 VAC. Check the hot surface igniter's resistance at room temperature and amperage draw during heat-up; replace if amperage isn't within 3.5 to 5.0 Amps or resistance isn't within 40-100 ohms (at room temperature), and inspect for overheating due to damaged refractory. Verify the blocked vent switch isn't bouncing; adjust or replace if necessary. Confirm proper inlet static and dynamic gas pressure, ensuring it's between 3.5" WC minimum and 14" WC maximum. Adjust combustion to achieve proper CO2 levels. Ensure a proper ground connection from the flame control to the burner housing. Lastly, check that the condensate trap isn't blocked, causin...
How to fix ID Card Fault on Riverside Hydronics HeatStation HS 1000?
If your Riverside Hydronics Boiler displays an ID Card Fault, check that the proper ID card is securely connected and perform a power and system reset.
What to do if Riverside Hydronics HeatStation HS 1000 has LWCO Fault?
If your Riverside Hydronics Boiler displays an LWCO Fault, check the LWCO switch and connections, and verify the water level.
How to troubleshoot Water Pressure Fault in Riverside Hydronics Boiler?
If your Riverside Hydronics Boiler displays a Water Pressure Fault, check the piping for leaks and inspect the pressure switch and its connections.
General| Brand | Riverside Hydronics |
|---|---|
| Model | HeatStation HS 1000 |
| Category | Boiler |
| Language | English |
To Next Page
