RIVERSMITH River quiver - Step 1: Prepare Vehicle; Prepare Vehicle

To Next Page

To Previous Page

STEP 1

Prepare Vehicle - DO NOT ASSEMBLE RIVER

QUIVER HALVES UNTIL STEP 3

STEP 1

Measure from center of front crossbar to estimated

location of the River Quiver reel box. Generally it is

best to spread vehicle crossbars as far as possible.

• If 65” or less both Quick Release Mounts will go

on the reel box side of the coupler.

• If more than 65” one Quick Release Mount

will go on each half of the river quiver. This

installation is preferred when possible.

NOTE: Quick Release Mounts are lower-profile than

Standard Mounts and may require flipping the River Quiver

upside down to avoid the Reel Box hitting the roof of your

vehicle.

Flip unit upside down if Reel Box

is touching the vehicle’s roof

Reel Box