Rivulis F2400 - General Instructions for F2400 Media Filter; Assembly and Installation of F2400 Media Filter

www.Rivulis.com
Rivulis F2400 Media Filter
2
1. GENERAL INSTRUCTIONS
The F2400 Sand Filter is designed and manufactured to achieve the highest standards of
quality and finish. This media filter uses gravel (or sand) as a bed that captures the
suspended matter in the water that flows through it. Media filters are particularly effective
for filtering algae, organic matter and recycled water.
Rivulis F2400 nozzle media filters uses a unique design of a double bottom chamber,
divided by a welded reinforced steel plate, which is suitable in particular for back-flushing.
The option of arm collectors is also available
For best results, the filter must be installed, operated and maintained according to the
following instructions. Special attention must be given to proper back flushing at the
specified periodic intervals, chlorination at the beginning and at the end of the season and
an appropriate maintenance.
F2400 Media Filter Nozzles/Arm collectors ‒ Amount of media
Required for Each Filter
Body Diameter
Inlet
Backwash flow
Media bed
weight -
Nozzles
Media bed
weight - arms
(pulgadas)
(mm)
(pulgadas)
(mm)
(m³/h)
(kg)
(kg)
16
400
2
50
5
50
75
20
500
2
50
8
75
100
24
600
2
50
12
125
150
28
700
3
80
17
150
225
36
900
3
80
24
375
500
48
1200
4
100
45
550
800
Table 1. Amount of media and minimum backflush flow required for each filter
2. ASSEMBLY & INSTALLATION
 If installing more than 1 filter (in array), make sure to leave enough space for later
maintenance.
NOTE: If the distributor does not supply the media, refer to “recommended media” for
information.
 The water used for the hydraulic control of valves must be filtered and supplied from the