Need help?Do you have a question about the RNA ESG1000 and is the answer not in the manual?
General| Managed | Yes |
|---|---|
| Digital Inputs | 8 |
| Digital Outputs | 8 |
| Analog Inputs | 4 |
| Analog Outputs | 2 |
| Data Link Protocol | Ethernet |
| Communication Ports | RS-232, RS-485 |
Describes the control unit's capability to supply RNA-control units and its intended application.
Details the regulations and applied harmonized standards the control device complies with.
Lists key technical specifications including mains connection, output voltage, load current, fuse, and dimensions.
Highlights essential safety measures, warnings about electric danger, and requirements for qualified personnel.
Lists critical checks before making mains connection and switching on the control unit.
Advises setting minimum output voltage before initial starts or after repair/exchange.
Defines the two operating modes (asymmetrical/symmetrical) and their impact on oscillating frequency.
Explains how to select operating mode using jumpers in the load plug and connector jack colours.
Details how to switch the control unit to operate with different mains voltages (e.g., 115V vs 230V).
Provides guidance on adjusting output voltage, emphasizing using RMS meters and safety transformers.
Explains how to switch the control unit for operation between 230V and 115V mains supplies.
Details methods for external control of the drive, including potential-free contacts and voltage signals.
Explains how to adjust the soft start run-up time using a trimmer for drive protection.
Illustrates the layout of operating elements, switches, and connections on the control unit boards.
Details the connection and functionality for releasing the drive using a voltage signal.
Provides detailed physical dimensions and layout of the ESG1000 control unit.
Presents the electrical connection diagram for the ESG1000 control unit, including power and load connections.
Explains how to select the oscillation frequency based on connector configurations.
To Next Page
