English English
SNOOZEFUNCTION
When the alarm sounds, pressing the SNOOZE Button (7) will
temporarily stop about 9 minutes then the alarm sounds again.
SLEEPFUNCTION
1. This function enables you to go to sleep listening to the Radio.
2. Set the FUNCTION Selector (1) to OFF or AUTO.
3. Press the SLEEP Button (13). The clock display will show 59
minutes. The Radio turns on and will turn off automatically after
59 minutes.
4. To increase 1 hour or to select a shorter time press the HOUR
Button (2) or MINUTE Button (3) while holding the SLEEP Button
(13) until the desired sleep time is displayed.
5. To turn off the Radio at any time during the Sleep period, press
the SNOOZE Button (7).
WAKETOTHERADIO
1. Set the alarm time as shown above.
2. Set the FUNCTION Selector (1) to the ON position.
3. Set the VOLUME Control (10) to ON.
4. Set the Band Selector (8) to the desired radio band, and follow the
procedure in LISTENING TO THE RADIO to tune the radio to a station.
5. Set the VOLUME Control (10) to a level you feel will wake you.
6. Set the FUNCTION Selector (1) to the AUTO position.
7. To switch off the alarm either press the ALARM OFF Button (5) or
set the FUNCTION Selector (1) to the OFF position.
LISTENINGTOTHERADIO
1. Set the FUNCTION Selector (1) to the ON position.
2. Set the VOLUME Control (10) to the ON position
3. Set the BAND Selector (8) to the desired band (FM or MW).
4. Turn the TUNING Knob (9) until the desired station is heard.
5. Adjust the VOLUME Control (10) to a comfortable listening level.
6. To turn off the radio, set the Function Selector (1) to the OFF
position.
Note: For FM reception there is a built-in FM antenna wire at the rear
of the unit. Move the wire around to obtain the best reception.
The AM band uses a built in directional aerial. You may have
to rotate the clock radio for the best reception.
5 6
To Next Page
Loading...
Need help?
General
