5 English
CD-MP3 OPERATION
1. Select “CD” mode by pressing the [MODE] button (2) repeatedly;
2. Press [OPEN/CLOSE] (7) to open the [CD DOOR] (6) and place a CD with the
label up in the CD compartment.
3. Close the [CD DOOR] (6). Focus search is performed and playback will start
automatically from the first track.
PROGRAMMING
Up to 99 tacks (MP3, 20 in CD) can be programmed and play in any order.
1. Stop the playback by pressing [STOP] (9);
2. Press [PROGRAM] (16), the display will show the number of the track on
the left side and the number of program on the right side.
3. Select desired track by using [SKIP -/+] buttons (10/11);
4. Press [PROGRAM] (16) to confirm desired track into the program mem-
ory;
5. Repeat step 3 and 4 to enter additional tracks into the program memory.
6. When all the desired tracks have been programmed, press [PLAY] (8) to play the
disc in the order you have programmed.
Note: Press [STOP] (9) twice to terminate programmed play.
TAPE OPERATION
1. Select “TAPE” mode by pressing the [MODE] button (2) repeatedly;
2. Press [EJECT] (23) to open the [CASSETTE SLOT] (18) and insert your tape;
3. Close the [CASSETTE SLOT] (18);
4. Press [PLAY] (20) to start playing tape.
Press [PAUSE] (24) when you want to stop playing tape operation temporarily,
press again to resume tape operation.
Press [STOP/EJECT] (23) when finished, press again to open the door.
Press [F.FWD] (22) or [RWD] (21) to start rapid tape winding either forward or re-
verse direction.
CASSETTE RECORDING
1. Insert the cassette into the [CASSETTE SLOT] (18);
2. Perform normal playback of the source you want to record;
3. Press the [RECORD] (19) and [PLAY] (20) buttons together to start recording;
4. Once the record is finished, press the [STOP] button (23) to stop recording.
To Next Page
Loading...
Need help?
General
