INSTALLATION
Place the urn on a solid, flat level surface with the tap facing the user. It is
highly recommended to position the urn with the tap away from the edge of
the bench in order that small children do not reach up and accidentally burn
themselves. Before connecting the urn to the power supply, ensure that the
“ON/OFF” switch is set to the “OFF” position and that the thermostat knob is
rotated fully in an anti-clockwise direction to the lowest setting.
Connect the urn to a standard, single phase, 10A or 15A power point (use a
standard 13A or 16A power point for international models). We recommend
that the electrical circuit supplying the power point be protected by an
approved earth leakage device.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any
situation where specifications allow a distance of less than 100mm we would
still recommend that a well-ventilated air gap of not less than 100mm be
maintained. If the machine is near particularly heat-sensitive materials
common sense should be employed in determining sufficient distancing.
Care has been taken when designing these machines to limit external surface
temperatures. In normal operation at 25°C the surface temperature of the
body should not exceed 60°C, due to the double-skinned design. Note that
higher temperatures will occur on the lid as the steam vapour rises – for this
reason we have placed additional warnings on the lid.
The Urns have been designed to be as safe as possible but, because these
machines are frequently placed in publicly accessible areas, it is
recommended that a Hazard assessment be carried out and additional
signage or protection be placed around the machine if warranted.
Do not attach any other items to this machine, or use contrary to what is
described in this manual.
To Next Page
Loading...
