Robert Sorby ProEdge - Additional Operational Safety; Tool Handling and Maintenance; Preventing Unintentional Starts and Accessory Safety

5
WARNING
• SECUREWORK.Use clamps or a vice to hold work when practical. It’s safer than using
your hand and it frees both hands to operate tool
• DON’TOVERREACH.Keep proper footing and balance at all times
• MAINTAINTOOLSWITHCARE.Keep tools sharp and clean for best and safest
performance. Follow instructions for lubricating and changing accessories
• DISCONNECTTOOLSbefore servicing: when changing accessories and belts
• REDUCETHERISKOFUNINTENTIONALSTARTING.Make sure switch is in o
position before plugging in
• USERECOMMENDEDACCESSORIES.Consult the owner’s manual for recommended
accessories. The use of improper accessories may cause risk of injury to persons
• NEVERSTANDONTOOL.Serious injury could occur if tipped or if the cutting tool is
unintentionally contacted
• CHECKDAMAGEDPARTS.Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and
perform its intended function - check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may aect its
operation. A guard or other art that is damaged should be properly repaired or replaced
• DIRECTIONOFFEED.Feed work into a blade or cutter against the direction of rotation
of the blade or cutter only
• NEVERLEAVETOOLRUNNINGUNATTENDED.TURNPOWEROFF.Don’t leave tool
until it comes to a complete stop