Roberts CR9916 - Setting the Time; Adjusting Hour and Minute

Switching on and setting the time
Before using your CD clock radio you must first set the correct time.
1. Place the unit on a flat surface. Plug the mains lead into a wall socket
and switch on.
2. The clock display will show 12:00. Ensure that the Alarm 1 and Alarm
2 function switches are set to the 'Off' position.
3. Press and hold down the Time Set button. The time will flash in the
display.
4. Whilst holding down the Time Set button press the Down button to
set minutes and the Up button to set the hour. Release the buttons
when the correct time is reached. The clock uses a 12 hour display with
a PM indicator. Ensure that the correct 12 hour cycle is selected.
3
ON
Down/
B.skip
CD Display Time Set
Up/
F.skip
PM
1
2
1
2
Adj
Adj
On
On
Off
Off
Music
Buzz