17
Stereo / Mono setting - FM
Your radio will play stereo broadcasts in stereo so long as the received
signal is of adequate strength. However, as a stereo signal becomes weaker
the audio signal will become poorer. It may be preferable to force the radio
to play the station in mono in order to reduce the level of audio noise.
1. Press and release the On / Off button to switch on your radio.
2. Tune to the required FM radio station as previously described.
3. If a station being received is weak some hiss may be audible. To
reduce this, press and release the Select button so that the display
shows ' Force mono'. Your radio will switch to mono mode.
4. To return to stereo/mono mode, press and release the Select button
so that the display shows 'Auto'.
3,4
1
Force mono
Auto
To Next Page
Loading...