After the lap speed disappears, the lap counter will increase by one to indicate the current lap number and
the running time of the current lap appears. You may take up to 1000 lap readings for each timer.
Upon completion of the event, press and hold (A), (B) and/or (C) for two (2) seconds to Stop timing.
“STOP” appears when all timers are stopped. The last lap time shown at “STOP” will be the actual lap
time (not 2 seconds later).
Separate Starting Times
Should you want to start each speed timer on its own, select “SEP” during the set-up procedure. “SEP”
will appear.
Press (A) to start Speed Timer #1, press (B) to start #2 and press (C) to start #3 at the beginning of the
event.
Then, press (A), (B) or (C) to take the lap speed readings. Again, you may release the previous speed
display to the current running lap time by pressing (E).
To stop, press and hold (A), (B) or (C) for two (2) seconds, to stop the associated speed timer. “STOP”
will appear when all speed timers have stopped. The time shown will be the actual time, not 2 seconds
later.
Press and hold (B) for two (2) seconds to reset all speed timers to zero.
ADVANCED FUNCTIONS
The fastest (“MAX”), slowest (“SLOW”) and average (“AVG”) lap times and speeds can be displayed
while the Speed Timer is running or stopped by pressing (F). The corresponding lap number will appear
next to the actual reading. The lap time will appear for two (2) seconds and then convert to the lap speed
for each reading.
150 Memory Recall
Continue to press (F) to recall up to the previous 150 lap times and speeds for each timer. The lap time will
appear for two (2) seconds after which the lap speed appears. The recall (“RCL”) indicator will appear
when in use. You may press and hold (F) to scroll through the recall sequence. Press (E) at any time to
escape “RECALL” and return to the most recent display.
NOTES:
The Memory Recall function will operate while the Speed Ti
mer is running or stopped . . . but NOT reset.
ALWAYS retrieve MAX/SLOW/AVG and Memory Recall data prior to resetting the Speed Timer.
Memory Recall Direction can only be changed in the Reset position.
To change modes during Speed Timer operation, press and hold (E) for two (2) seconds.
PART VI. COUNTDOWN TIMER OPERATION
The SC-888 has three (3) Countdown Timers. A countdown timer shows the time remaining in an event,
similar to the Game Clock at a football game.
To Next Page
Loading...
