Robin EH035 User Manual

- 9 -
STOPPING
OFF
ON
OFF
1
■
Set the throttle lever at the low
speed position and allow the engine
to run at low speed for 2 or 3
minutes before stopping.
■
If the stop switch is installed on the
engine.Set the stop switch to the
position "OFF or O ".
■
If the stop switch is installed on a
machine side.Set the stop switch to
the position "OFF or O ".
STOP SWITCH
■
Pull the starter handle slowly and
return the handle to its original
position when resistance is felt.
NOTE :
The above operation is necessary to
prevent outside moist air from
intruding into the combustion
RECOIL STARTER
;;
;;;
;;;
2
■
After starting the engine, gradually
open choke by turning the choke
lever and finally keep it fully
opened.
■
Do not fully open the choke lever
immediately when the engine is
cold or the ambient temperature is
low, because the engine may stop.
CHOKE LEVER
5
Allow the engine to warm up
without load for a few minutes.
Gradually move the throttle lever
toward the high speed position
and set it at the required engine
speed.
NOTE :
If the engine is operated at upside
down, white smoke may be
exhausted from the muffler.
RUNNING
EH035Vus_EU2308 06.12.22 10:07 AM ページ9

Robin EH035 Specifications

General

Brand	Robin
Model	EH035
Category	Engine
Language	English