Robin EHO9-2D - Page 20

– 18 –
MAIN BEARING
COVER CP
M6 x 30 BOLT AND
WASHER AY : 9 pcs.
SPACER
CRANKSHAFT
CAMSHAFT
SEALANT
(
Three bond 1280B or 1216
)
CRANKCASE
(2) MAIN BEARING COVER
Lubricate the oil seal and bearing surfaces.
*Coat the suface of the main bearing cover with sealant (Three bond 1280B or 1216).
Place spacer chosen in STEP (1) on crankshaft.
Use an oil seal guide when installing the main bearing cover to avoid damaging the oil seal.
Tap the cover into place with a soft hammer.
M6 x 30 mm bolt and washer : 9 pcs.
Tightening torque
10 - 12 N•m
(100 - 120 kgf•cm)
(7.2 - 8.7 ft•lb.)