Robin EHO9-2D - Page 22

– 20 –
2-2-9 ROCKER ARMS AND PUSH RODS
(1) Insert push rods into crankcase. Put push rod tip in the hollow of tappet top.
* An oil return slot is located next to the tappet boss. If you do not put the push rod in the tappet
properly, the push rods will fall into the crankcase. Removal of the main bearing cover is necessary to
get them out.
(2) Apply oil to rocker arms and assemble them to cylinder head using pivot bolt and nut.
GASKET
PUSH ROD
BOLT
(
PIVOT
)
: 2 pcs.
COLLET VALVE
SPRING RETAINER
VALVE SPRING
ROCKER ARM
M6 NUT
: 2 pcs.
GUIDE PLATE
CYLINDER HEAD
EXHAUST VALVE INTAKE VALVE
M8 x 55 x 12.5
BOLT : 2 pcs.
M8 x 55 FLANGE
BOLT : 2 pcs.
GASKET
GASKET
ROCKER COVER
BREATHER PLATE
OIL SHELTER
PLATE
PIPE KNOCK
M6 x 75 FLANGE
BOLT : 4 pcs.