Robin RGV7500 - Page 24

−
14
−
(1) AC APPLICATION
(a) Check the voltmeter for proper
voltage.
■
This generator is thoroughly tested
and adjusted in the factory.
If the generator does not produce the
specified voltage, consult your
nearest Robin dealer or service shop.
(b) Turn off the switch (es) of the electrical
appliance (s) before connecting to the
generator.
(c) Insert the plug (s) of the electrical
appliance(s) into the receptacle.
■
Check the amperage of the
receptacles used referring to
TABLE
1
, and be sure not to take a current
exceeding the specified amperage.
■
Be sure that the total wattage of all
appliances dose not exceed the rated
output of the generator.
(d) Turn the breaker on to see if the pilot
lamp lights up.
(e)Turn on the switch of the appliance.
ON
OFF
PILOT LAMP
RGV7500RAi取説GU201805.4.41:25PMページ14