Robit V7S Pro User Manual

Quick Operation Guide
Robit V7S Pro
Robot Vacuum Cleaner
Attention Before Use
Please neatly arrange desks, chairs and household appliances to prevent the robot
getting stuck during cleaning.
Please do not stand in such narrow areas as doorways and aisles in case the robot
fails to clean these areas.
The messy power cords, toys and other objects on the floor may entangle the robot,
please kindly organize them.
Remove the white protective strip and the transparent protective film on the infrared
front bumper before using. Otherwise, the robot may not work properly.
Charging the Robot
Preparation before charging
Before installing the charging base, remove the protective film on the charging
Base, and wipe the installation ground till clean.
1
English

Robit V7S Pro Specifications

General

Model	V7S Pro
Type	Robot Vacuum Cleaner
Battery Capacity	2600mAh
Run Time	Up to 120 minutes
Water Tank Capacity	0.3L
Filter Type	HEPA Filter
Charging Time	About 4-5 hours
Control Method	Remote Control
Dust Collection Type	Bagless
Noise Level	<65dB
Features	Auto Charging

Summary

General Operation Precautions

Pre-Operation Setup Advice

Arrange furniture, avoid narrow areas, and clear floor clutter like cords to prevent robot obstruction.

Front Bumper Protection

Remove protective strip and film from the front bumper for correct robot sensor operation.

Charging the Robot

Charging Base Setup

Prepare the charging base by removing protective film and ensuring the installation ground is clean before setup.

Side Brush Installation

Ensure the side brushes are properly installed on the robot for effective cleaning.

Charging Modes

Understand the robot's indicator lights and methods for charging via power adapter or charging base.

Cleaning Operations

Starting Auto Cleaning

Initiate auto cleaning mode using the robot or remote control; the robot plans its route intelligently.

Robot Movement and Pauses

Avoid moving the robot during cleaning; it may pause for route calculation and replanning.

Turning Robot On/Off

Learn how to start and stop the robot using the start-stop button or remote control.

Power Off Procedure

Robot Power Switch

Turn the side power switch to '0' after cleaning to power off the robot and turn off the indicator.