5. When the cleaning cycle is completed, Unplug the 100V/240v socket. Pull the robot out of the pool by the handle on the Pool
Cleaner. NOTE: Do not lift the Pool Cleaner out of the water by using the floating cable.
6. Remove the Base Plate and clean the Filter Bag:
Unlock the Latches on the Base Plate and remove the Filter Bag from Base Plate, clean the Filter Bag. Once clean
put the Filter Bag back onto its frame and put it back into the Pool Cleaner after the Filter Bag is dry.
(Note: when re-fitting the Filter Bag to the Base Plate, please ensure the short side “TAG” is at one of the short ends of the
base plate).
To Next Page
