Robomow RS622 User Manual

14
Robomow S models
P Feed both the Perimeter Wire (A) and the Extension Cable (B)
through the slot in the rear side of the Base Station.
P Attach the Perimeter Wire connector to the Base Station Head (A).
P Attach the 20 m (65 ft.) Extension Cable to the Base Station Head (B), if
not already connected.
P Make sure that the Perimeter Wire and the 20 m (65 ft.) Extension Cable
are through the slot in the back of the Base Station.
P Align the Base Station Head to the front of the Base Station (
C).
) Slide it in place along the side channels.
) Push forward until the Head clicks into place.
P Feed the 20 m
(65 ft.) Extension Cable all the way to the Power
Box.
2.7 Placing The Base Station
Place Base Station on the Perimeter Wire.
P Position the Base Station front facing a Anti Clockwise direction along the
lawn’s edge.
P Place the Base Station on the Perimeter Wire.
P Align the center marking on the front of the Base with the wire.
P After the Base Station has been positioned, insert 2 rear stakes into the
Base Station holes. Only after the complete setup will be tested, you will
insert the 4 remaining stakes (See Section 3.3.5).
A
A
B
C
B
Insert 2 rear
stakes

Robomow RS622 Specifications

General

Brand	Robomow
Model	RS622
Category	Vacuum Cleaner
Language	English