Robomow RS622 User Manual

17
Preparing Robomow
If you wish to quit the process during a setup:
3.3.1 Select Language:
3.3.2 Set Date:
3.3.3 Set Time:
3.3.4 Test Base Station Position
P Press to start the test.
Robomow drives towards the Base Station and
Searching Base is displayed.
If the mower does not start the test, then one of the
following messages will be displayed:
No Wire Signal – Confirm that the Power Box is connected
to the plug socket and that the extension cable is
connected at its both sides: to the Power Box and to the
Base Station.
Change wires in plot connector – The Perimeter Wire
has been connected in the opposite direction. Swap the
wires at the plot connector.
3.3.5 Peg Base
P Insert the remaining
4 Stakes of the Base Station,
to secure it to the ground.
Robomow enters to the Base Station, drives back, waits in front of
the Base Station and Peg Base is displayed.
If a Reposition Base Station message is displayed:
o Slightly move the Base Station to align it with the
Perimeter Wire.
o Check for any obstacles that may interfere with the
mower’s entrance to the Base Station.
Stakes x 4
Scroll to select a value hh:mm.
Press
to set a value.
Press
S T O P
to proceed
Scroll to select
mark.
Scroll to select a language. Press
.
Scroll to select a value dd/mm/yy.
Press
to set a value.

Robomow RS622 Specifications

General

Brand	Robomow
Model	RS622
Category	Vacuum Cleaner
Language	English