Peg the two Perimeter Wires down to the ground using the
same peg leaving enough loose wire.
Twist together the two loose parts.
Insert the end of the wire without the connector into the hole of the other
wire’s connector. Use a small flat screwdriver to tighten and secure this
wire into the connector.
2.6 Assembling the Base Station
2.6.1 Laying and fastening power cord
-
Safety – Avoid injury!
The Extension Cable should be securely fastened to the ground!
It should never present a tripping hazard.
The power cord should cross over soft surfaces ONLY. It should not cross
over hard surfaces (e.g. sidewalk, driveway) where it cannot be securely
fastened.
2.6.2 Base Station Assembly
2.6.3 Base Station Head and Base:
Remove the Base Station Head from the Base.
Electric Shock Hazard!
Disconnect the Power Box from the plug socket before any approach to the Base
Station charging contacts (pins).
Pull the lever (A) upward
Push the Base Station head from the front side in the
direction marked B.
The head will slide out.
Stakes x 6
Base
Base Station Head
(Charging Adaptor)
Small flat screwdriver
Flippers x 2
A-Pull
B-Push
To Next Page
Loading...