Roborock S7 Max Ultra Series - Scheduled Cleaning Failures; Mopping and Water Issues; Resuming Cleaning After Charging; Dock Return and Spot Skipping

14
Common Issues
Is power always being drawn when the
robot is on the charging dock?
•
The robot will draw power while it is docked to maintain battery performance, but power
consumption is minimal.
Does the robot need to be charged
for at least 16 hours the rst three
times it is used?
•
No. The robot can be used any time after it has been fully charged.
Problem Solution
No or little water during mopping
Cleaning does not
resume after recharging
•
Check whether there is water in the water tank and use the mobile app to set the scrub
intensity or check the manual for full instructions on how to correctly install the mop cloth and
mop mount.
•
Make sure that the robot is not in DND mode. DND mode will prevent cleanup. When cleaning
a space requiring a top-up charge, if the robot was placed manually on the charging dock
before it returned to the dock automatically, it will not be able to continue cleanup.
The robot has begun to
miss certain spots
It takes a long time to ll the water tank
•
The wall sensor or cli sensors may be dirty. Wipe them with a soft dry cloth.
•
The lter may be blocked and need cleaning.
The robot cannot return to the
charging dock after Spot cleaning or
when it has been moved manually
•
After spot cleaning or a signicant position change, the robot will re-generate the map. If the
charging dock is too far away, it may not be able to return to recharge and must be placed on
the charging dock manually.
Scheduled cleaning
is not working
•
Keep the robot charged. Scheduled cleaning can only begin when the battery level is above
20%.