®
Blixer 5V and
®
Blixer 6V Operation Manual
2
CAUTION:
Always connect the Robot Coupe to a grounded
outlet with Ground fault circuit interrupter
(GFCI) protection device.
Disconnect the machine from the power outlet
when not in use and when cleaning or servic-
ing the unit.
Machine must be operated and stored in a lo-
cation not subject to water drips or spray or ex-
plosive vapors.
The machine must not be modified in any way
from its original configuration.
Should the machine malfunction or should any
part be damaged, it must not be operated until
it is repaired by a qualified technician using only
genuine Robot Coupe® repair parts.
Operating times of 5 minutes or longer can
cause processed food to increase to tempera-
tures above 125 F.
Failure to follow operating instructions or at-
tempts to operate the machine outside its de-
sign limits may create a hazardous condition
that could damage the machine and /or injure
users.
The machine must be operated on a clean sturdy
counter or table. Keep the area around and
under the machine clear to allow air circulation.
Otherwise, the motor can overheat.
I. INTRODUCTION
The Robot Coupe commercial food processor performs a host
of culinary feats. It is specifically designed for high speed and
quality vegetable processing. The Robot Coupe also provides
a wealth of safety and operating features to make volume
food preparation a pleasure rather than a chore.
Machine specifications:
The Models
®
Blixer 5V and
®
Blixer 6V are equipped with
variable speed motors generating 1 HP which plug into a
standard 120 volt 60 HZ, 15 amp power outlet. The full load
amperage rating is 12 amps. The machines are supplied with
stainless steel bowls, with S-blade, clear polycarbonate cover,
and a bowl/lid wiper assembly. The
®
Blixer 5V has a 5 1/2
quart capacity and the
®
Blixer 6V a 7 quart capacity.
The unit is equipped with a thermal overload circuit breaker.
If the unit overheats due to an overload condition, it will
automatically shut off. After cooling a few minutes the thermal
overload circuit breaker may be reset. Press the reset button
located on the bottom right front of the unit.
The manual should be read completely by the
operator before any attempt is made to use the
machine. Also, the manual should be referred
to any time there is a question on operation.
If the machine fails to operate as described in
this manual, or if the machine malfunctions in
any way, remove the machine from use and have
it serviced. Additionally, discard all food pro-
cessed at the time of the malfunction.
This manual should be kept within easy access
to all users for reference, and should be read
completely by all first time users of the machine.
Special attention should be given to the use of
the operation controls and safety features
designed for this machine.
CAUTION: Your Robot Coupe comes with a
sharp cutting blade. Always handle with safety
in mind. We suggest that a pair of cut-resistant
gloves be worn when handling the blade.
To Next Page
Loading...
