21
Eng
CLEANING
• MOTOR BASE
Never immerse the motor base in water. Clean
using a damp cloth or sponge.
• CUTTER
After removing the lid, remove the bowl from the
motor base by pushing the trigger fitted in the
handle. Pull up to disengage, leaving the blade in
the bowl in order to prevent any spillage when
working with liquids.
If the food has a solid consistency, remove the blade
and empty the bowl.
Replace the bowl, place the blade back on the shaft
and switch on the machine in order to remove any
mixture which may have stuck to the blade.
If you wish, you can rinse the bowl by filling it with
hot water and switching on for a few minutes.
• BLADE
The stainless steel blade of R 6 - R 6 V.V. is easy to
dismantle and to clean.
After cleaning the blade, always dry the blades well
to prevent rusting.
The quality of the cut depends mainly on the
sharpness of your blades and the degree of wear.
The blades are actually wearing parts, which
should be replaced occasionally to ensure consistent
quality in the final product.
• MOTOR SEAL
The motor seal on the shaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the motor seal regularly for
wear and tear and replace if necessary.
The motor seal can be easily replaced without
having to remove the motor, so we strongly advise
you to ensure that is in good condition.
TECHNICAL
SPECIFICATIONS
• WEIGHT
Net Gross
R 5 Plus 24 kg 26 kg
R 5 V.V. 25 kg 27 kg
R 6 25 kg 27 kg
R 6 V.V. 26 kg 28 kg
MAINTENANCE
• BLADE
We strongly recommend that the blades (smooth
ones) are sharpened daily using sharpening stone
supplied with machine.
Ensure power supply to machine is disconnected.
1 - Place blade dismantling tool over shaft onto
motor base.
2 - Fit blade onto shaft ensuring it is correctly
positioned.
3 - Insert bar into blade cap and turn anti-clock-
wise to dismantle .
When re-assembling do not over tighten.
A - Upper blade.
B - Lower blade.
W A R N I N G
I M P O R T A N T
Check that your detergent is suitable for
cleaning plastic parts. Some washing agents are
too alkaline (e.g. high levels of caustic soda or
ammonia) and totally incompatible with certain
types of plastic, causing them to deteriorate
rapidly.
As a precaution, always unplug your
appliance before cleaning it (hazard of
electrocution) and handle the blades with
care (hazard of injury).
To Next Page
Loading...
